| This course covers basic
DX hardware, its installation and operation, and the software
engineering to properly meet a specification using the DX-9100 systems. Pre-Requisites:
Students will need to have a laptop with M-TOOLS loaded.
Course Objectives:
- Define the purpose and construction of the
DX-9100 and the various XT-9100 devices.
- Define how to install and maintain DX-9100
devices.
- Define the purpose of an N2 bus, how it is
installed and typical problems.
- Given a sequence of operation and the
GX-9100 tool, write, download, and test a program for primary plant
equipment and an Air Handling Unit.
- Given a typical problem, troubleshoot it
down to a component.
|
Click a date for the registration form
7/8 - 7/11/08 Madison
Heights (.pdf)
Cost: $600.00
Instructor: Ron VanderMeer
Time: 8:00 - 4:30 pm
To request this training for your
location click here for the Onsite Training Request Form
Other Johnson Controls Training Available:
HVACPro Engineering
N30 M3 Engineering
FX Builder Express
FX Builder
FX40 Engineering
DX Front Panel Lunch & Learn |